Steel Briquetting Machine

This SBJ-2000 scrap metal briquette press is mainly applied in the aluminum alloy section plant, steel casting foundry, aluminum casting factory, copper casting plant, etc. It compresses the waste metal into briquette for melting again instead of the scrap steel, pig iron, aluminum ingot and...

Send Inquiry

Chat Now

Operating procedures of metal chip briquetting machine

With the development of technology, the metal shavings cake press is continuously upgraded. At present, it can squeeze various metal scraps, steel shavings, scrap steel, scrap iron, scrap copper, scrap iron, iron shavings, and metal raw materials into a circle. Pie-shaped. After such treatment, it is convenient for storage, transportation and recycling of various metal scraps. If the iron chip cake press strictly follows the operating procedures, a lot of unnecessary troubles can be avoided.

1. Manually press one or more pieces of material, and observe whether the punch and die sleeve are loose and offset. (The indenter, die sleeve and drawing plate are seriously worn and should be replaced, otherwise it will affect the pressing material and will cause problems such as difficulty in forming).

2. After confirming that each part is normal, switch to automatic operation. Continuously observe the operation status of each program during operation. If there is a stagnation, oil leakage, etc., it should be shut down immediately. Please have an experienced maintenance worker to check and repair.

3. The operator of each shift must clean the machine before leaving work, remove oil and dust, and keep the inside and outside of the electrical control cabinet tidy.

3_01